Pioneer SE-E6BT Manual De Instrucciones página 5

7. Pairing
Pairing must be performed before the headphones can be used to listen to music
or communicate using a Bluetooth device.
For further details regarding the pairing procedure, consult the user's manual for
your Bluetooth device.
(1) While the power of the unit is off, hold down the Power button until the
unit enters pairing mode.
• The pairing mode is confirmed by the LED indicator's alternately flashing blue
and red.
Release the Power button after confirming that the LED indicator is alternately
lighting blue and red.
• When in the pairing mode, if pairing is not completed within about 10 minutes,
the power will automatically turn off.
(2) Turn on the power to the Bluetooth
begin pairing; search for this unit (wireless headphones) from the paired
Bluetooth device.
• Set the Bluetooth device close (within one meter) to the wireless headphones.
• These wireless headphones will appear in the Bluetooth device's display as
"SE-E6BT".
(3) Confirm that pairing has been successfully completed with the
device.
• Look at the display for the Bluetooth-enabled device and select "SE-E6BT".
• When the LED lamp is flashing in blue slowly about once every 3 seconds, pair-
ing is complete. When it is flashing quickly about once every second, pairing is
not complete.
• The PIN code for these wireless headphones has been factory set at "0000".
Input this code if requested by the Bluetooth device.
Connect to the Bluetooth device
• Confirm that the power to the wireless headphones is ON before connecting to
the Bluetooth device.
• Depending on the device, connection between the wireless headphones and
Bluetooth device may be effected automatically after pairing.
Disconnecting from the Bluetooth device
• Hold down the Power button until the flashing LED lamp turns off and the power
of the device turns off.
device you wish to pair with, and
Bluetooth
Note
• Depending on the device connected, the A2DP profile may need to be desig-
nated when playing music, and the HFP profiles for hands-free communication.
• For details regarding operating and setting methods, consult the user's manual
for the Bluetooth device.
• When a connection with the device becomes no longer possible, perform paring
again.
• These wireless headphones can record pairing information for up to 8 Bluetooth
devices. If pairing is performed for a ninth device, the information for the first
paired device will be overwritten and lost. If you wish to reconnect to that device
on a subsequent occasions, it will be necessary to repeat pairing with that
device.
• Whenever using a device with which pairing has been performed, first turn on
the power to the wireless headphones, then perform the connection operation
for the paired Bluetooth device.
Multipoint (The earphones allows connecting 2 Bluetooth devices at
the same time)
• Connect the earphones to the 1st Bluetooth device.
• Disconnect the earphones from the 1st Bluetooth device.
• Turn off the earphones.
• Hold down the power button until the unit enters pairing mode.
• Connect the earphones to 2nd Bluetooth device.
• Now connect the 1st Bluetooth device (by 1st Bluetooth device memory)
5
En