Publicidad
Idiomas disponibles
Idiomas disponibles
To reduce the risk of injury, turn unit off and disconnect it from power source before installing and
removing accessories, before adjusting or when making repairs. An accidental start-up can cause injury.
ASSEMBLY TOOLS REQUIRED
4mm Hex Wrench (supplied)
5mm Hex Wrench (supplied)
ASSEMBLY TIME ESTIMATE
This unit will take approximately 1 hour to 1-1/2 hours to assemble.
FRONT GUIDE RAIL
FOR MODEL 36-729 ONLY
1. Align the two holes in the front guide rail (A) Fig. 3
with the two holes in the front of the table.
2. Insert an M8-1.25 x 30mm flat head screw (B) Fig. 3
through the hole in the front guide rail and the table.
3. Place an 8mm flat washer and a 8mm lockwasher
on the screw. Thread an M8 x 1.25 hex nut on the
screw. Repeat this process for the remaining hole in
the front guide rail and the table.
4. Use a square (D) Fig. 4 to see if the front guide rail is
parallel with the table. Tighten the two screws that
hold the guide rail to the table.
FOR TABLE SAWS WITH SHEET METAL
EXTENSION WINGS - T 2 -30 ONLY
1. Align the four holes in the front guide rail (not shown)
with the four holes in the front of the table.
2. Insert an M8-1.25 x 30mm flat head screw through
the hole in the front guide rail and the table.
3. Place an 8mm flat washer and a 8mm lockwasher on
the screw. Thread an M8 x 1.25 hex nut on the screw.
Repeat this process for the remaining three holes in
the front guide rail and the table.
4. Use a square (D) Fig. 4 to make sure the front guide
rail is parallel with the table and tighten the hardware
that holds the guide rail to the table.
NOTE: The front and rear guide rails have three holes
(A) Fig. 5 in the extension end that are used to attach an
extension table. If you plan to install an extension table to
your machine, install it before attaching the guide tube.
ASSEMBLY
Standard Screwdriver
Phillips Screwdriver
Adjustable Wrench
5
Square
3mm Hex Wrench (not supplied)
A
B
FIG. 3
FIG. 4
FIG. 5
D
A
Publicidad
