Publicidad
Idiomas disponibles
Idiomas disponibles
To reduce the risk of injury, turn unit off and disconnect it from power source before installing and
removing accessories, before adjusting or when making repairs. An accidental start-up can cause injury.
ADJUSTING THE FENCE PARALLEL TO THE
MITER GAUGE SLOTS
TO SEE IF THE FENCE IS PARALLEL TO THE MITER
GAUGE SLOT:
1. Move the fence (A) until the bottom edge of the fence
is in line with the edge of one of the miter gauge
slots.
2. Push down on the fence clamping lever (C). The
fence (A) should be parallel to the miter gauge slot.
TO ADJUST:
1. Lift the fence locking lever (C) Fig. 11 and remove the
fence from the guide tube (Fig. 12).
2. Slightly tighten or loosen one of the two adjusting
screws (D) or (E) Fig. 12, using a 3mm hex wrench (F),
not supplied.
3. Place the fence on the guide tube and check the
alignment again.
IMPORTANT: Very little movement of the screws (D) and
(E) is necessary to adjust the fence.
ADJUSTING THE FENCE PERPENDICULAR
TO THE TABLE
To reduce the risk of injury, turn unit off
and disconnect it from power source before installing
and removing accessories, before adjusting or when
making repairs. An accidental start-up can cause injury.
1. Place a square (A) Fig. 13 against the middle of the
fence to see if the fence is perpendicular to the table.
2. To adjust, turn the adjusting screws (A) and (B) Fig. 14.
OPERATION AND ADJUSTMENTS
B
D
A
A
7
A
C
FIG. 11
E
FIG. 12
FIG. 13
B
FIG. 14
Publicidad
