Commercial Electric GUARDIAN GRD64-PC-4K-BZ Guía De Uso Y Cuidado página 8

Installation (continued)
6
Make the electrical
connections
If necessary, strip 3/8" of insulation from
junction box and lighting fixture wires (fig 15).
For Non-Dimming Electrical Wiring
(Follow these steps when NOT
wiring to a dimmer)
Connect light fixture black wire to junction box
black wire (line), light fixture white wire to
junction box white wire (common), and the light
fixture green wire to the junction box ground
wire (fig 16).
For the purple and pink unused fixture wires
either leave the wires unstripped or install wire
nuts (BB) on the ends to prevent electrical
hazard (fig 16).
NOTICE: Leave purple and pink wires terminated with
wire nuts installed and separated when NOT connecting
to a 0-10V dimmer. DO NOT connect the purple and pink
wires to any other wires unless wiring to a 0-10V dimmer
designed for use with LED light fixtures (fig 16).
Purple
(fig 15).
Pink
Non-dimming wiring diagram (fig 16).
Follow this diagram when NOT wiring
to a dimmer
For Electrical Wiring To 0-10V Dimmer
(Follow these steps when
wiring to a 0-10V dimmer)
Connect light fixture black wire to junction box
black wire (line), light fixture white wire to
junction box white wire (common) and the light
fixture green wire to junction box ground wire (fig 17).
For dimming, when wiring to a 0-10V dimmer,
connect the light fixture purple wire to the dimming
device wire (+DIM) and the light fixture pink wire to
the dimming device wire (-DIM) (fig 17).
(fig 16).
8
Please contact 1-844-548-3776 for further assistance.
Pink
Dimming wiring diagram (fig 17).
Follow this diagram when wiring
to a 0-10V dimmer
TIP: Hold stripped ends near each other and align any
frayed strands (do not twist wires).
Push the wires into wire nuts (BB) and use your fingers
to twist the wire nuts clockwise until tight. Check for
tightness by pulling wires.
(fig 17).
HOMEDEPOT.com