Commercial Electric GUARDIAN GRD64-PC-4K-BZ Guía De Uso Y Cuidado página 9

Installation (continued)
7
Caulk The Light
Fixture
Caulk around the back face of the
mounting plate cover (C) with silicone
sealant (not included) (fig 18).
NOTICE: Failure to properly caulk around the back face
of the mounting plate cover (C) and the surface could lead
to water damage to the fixture and is not covered under
the warranty.
NOTE:
When attaching this light fixture to a ground junction
box, caulk between the junction box and the weatherproof
mounting plate (not included) (fig 19).
Plug any
unused holes.
8
(fig 18).
Seal
around here.
(fig 19).
9
Adjust The Light
Head And Testing
Loosen the screw on swivel portion of the
knuckle mount (H) using the provided
allen wrench-2 (HH) (fig 20). Adjust the
fixture head (A) to a suitable aiming position,
and then tighten the knuckle mount tightening
screw (C) (fig 20).
Restore power to the circuit breaker and
light switch and test if light turns on.
Loosen the screw on
swivel portion of the knuckle
mount (H) using the provided
allen wrench-2 (HH).
Loosen the screw on
swivel portion of the knuckle
mount (H) using the provided
allen wrench-2 (HH).
(fig 20).