Montipower VINYL ZAPPER ULTIMATE CORDLESS Manual De Instrucciones página 14

EN Operating instructions
F
Figure 12
6.3 Setting speed
The rotating speed is preset and fixed at 1,250 rpm to ensure optimal performance.
The VTC electronics make material-compatible work possible and an almost
constant speed, even under load.
7. Cleaning
Motor cleaning: Hold the power tool firmly and
ventilation slots of the tool regularly and thoroughly (Figure 2).
8. Troubleshooting
8.1 Battery powered power tools:
• Overload protection: when there is a MAJOR reduction in load speed,
temperature is too high, allow the power tool to run at idle speed until it has cooled down.
• Overload protection: when there is a SLIGHT reduction in load speed.
overloaded, reduce the load before continuing to work.
• S-automatic safety shutdown: when the power tool SWITCHES OFF automatically.
the slew rate of the current is too high (for example, if the machine suddenly seizes or a
kickback occurs) and the power tool switches off, release the dead man's switch to switch
off the power tool. Then switch it on again and continue to work as normal.
• When the power tool is running but the Vinyl Zapper
toothbelt may be broken or heavily damaged and needs to be replaced. See Chapter 11,
Repairs.
9. Accessories
Use only original MontiPower
see www.montipower.com.
10. Repairs
Repairs to power tools must be carried out by qualified personnel ONLY! Contact your
local MontiPower
You can download specific repair instructions and a list of spares and assemblies from
www.montipower.com.
14
F
®
accessories. For a complete range of accessories,
®
representative.
VINYL ZAPPER
blow compressed air through the rear
®
Wheel does not rotate.
®
ULTIMATE CORDLESS
If the motor
If the machine is
If
The