Getting Started; Cancel The Demonstration; Set The Clock And Date; Set The Basic Settings - JVC KD-R690S Manual De Instrucciones

GETTING STARTED

1

Cancel the demonstration

When you turn on the power (or after you reset the unit), the display
shows: "CANCEL DEMO" "PRESS" "VOLUME KNOB"
1 Press the volume knob.
[YES] is selected for the initial setup.
2
Press the volume knob again.
"DEMO OFF" appears.
2

Set the clock and date

1
Press and hold .
2
Turn the volume knob to select [CLOCK], then press the knob.
To adjust the clock
3
Turn the volume knob to select [CLOCK ADJUST], then press the knob.
4
Turn the volume knob to make the settings, then press the knob.
Hour Minute
5
Turn the volume knob to select [CLOCK FORMAT], then press the knob.
6
Turn the volume knob to select [12H] or [24H], then press the knob.
To set the date
7
Turn the volume knob to select [DATE SET], then press the knob.
8
Turn the volume knob to make the settings, then press the knob.
Day Month Year
9
Press to exit.
To return to the previous setting item, press
4
ENGLISH
3
1
Press and hold
2
Turn the volume knob to select an item (see the following table),
then press the knob.
3
Repeat step
4 Press
To return to the previous setting item, press
SYSTEM
KEY BEEP
SOURCE SELECT
AM SRC *
PANDORA SRC *
BUILT-IN AUX *
F/W UPDATE
UPDATE SYSTEM
F/W UP xxxx
* Not displayed when the corresponding source is selected.
.

Set the basic settings

.
2
until the desired item is selected or activated.
to exit.
ON: Activates the keypress tone. ; OFF: Deactivates.
ON: Enables AM in source selection. ; OFF: Disables. ( 5)
(For KD-R690S)
ON: Enables PANDORA in source selection. ; OFF: Disables. ( 10)
ON: Enables AUX in source selection. ; OFF: Disables. ( 14)
YES: Starts upgrading the firmware. ; NO: Cancels (upgrading is not
activated).
For details on how to update the firmware, visit:
<http://www.jvc.net/cs/car/>.
.
Default: XX