Beko CEG 3194 B Manual Del Usuario página 36

6
Troubleshooting
Problem
Coffee is delivered too slowly
or a drop at a time.
Lack of bean indicator flashes
but there is still a lot of coffee
bean inside the container.
No milk foam out from the ma-
chine
No milk foam out from the ma-
chine
The hole of Milk tube connec-
tor is blocked by milk residues
which hardly to be cleaned
The milk froth is of poor quality
36 / EN
Cause
Coffee powder too fine which
block the water to come out.
Internal coffee powder outlet
is blocked.
The automatic milk frother is
dirty or not assembled or in-
stalled correctly
The hole of Milk tube connector
is blocked by milk residues
The milk tube connector not be
cleaned for a long time
The type of milk used is not
suitable for frothing
The temperature of the milk is
too high
Fully Automatic Coffee Machine / User Manual
Solution
Adjust the coffee fineness to
bigger dot during grinder op-
eration.
Follow the steps in Cleaning
the coffee powder outlet.
Clean the automatic milk froth-
er and make sure it is correctly
assembled or installed.
Refer to section "Daily Cleaning
of the appliance" ,follow "clean-
ing the milk container and con-
nection milk tube", Clean the
connector and make sure all
the hole on the connector is
clean, use needle or bristle of
brush to clean the hole.
Soaking the connection milk
tube into warm water for an
hour, follow the "cleaning the
milk container and connection
milk tube" in section "Daily
Cleaning of the appliance",
keep using frothing milk func-
tion to clean until water come
from dispenser smoothly. Use
needle or bristle of brush to
clean the hole
Different types of milk result in
different amounts of froth and
different forth qualities. Semi-
skimmed or full-fat cow's milk
gives good results.
No milk foam out from the ma-
chine