Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION: OVERLOAD:
-
If you use extension leads, these should have a cable cross-section of at least 1.5 mm2.
-
Do not use any multiple sockets, as this device is too powerful.
Use
1. Place the machine on a flat surface.
2. Open the kettle with the button in the lid. Fill it with water. Fill only up to the maximum mark (MAX).
You can read off the water level in the water level indicator.
3. Close the lid.
4. Place the kettle flush on the base.
5. Only connect the machine to a properly installed 230V, 50Hz safety socket.
6. Switch to position 1 (ON). The window will become illuminated with a blue colour, indicating that water
is being heated.
7. After boiling the machine switches off automatically.
8. Disconnect the machine from the mains electricity
Cleaning
WARNING:
- Always turn the device off before cleaning it and remove the mains plug. Wait until the
device has cooled down.
- Never immerse the device or the base in water or other liquids.
CAUTION:
- Do not use any wire brush or other abrasive objects.
- Do not use any acidic or abrasive detergents.
- Rinse the water container out with clean water. Then dry it off with a cloth.
- Clean the housing after use with a slightly damp cloth.
Decalcification
The frequency of the decalcifying operation depends on the hardness of the water and on how often the
appliance is used.
If the machine switches off before the water boils, it probably needs to be decalcified.
Please do not use vinegar but a commercially available decalcification agent on the basis of citric acid.
Only use the quantities stated in the instructions.
NOTE: After decaling the device, boils fresh water in it several times (approximately 3-4 times) in order to
remove any residues. Do not consume this water.
Technical Data
Model:
Power supply / Protection Class
Power consumption:
Filling quantity:
EK-22S.009B
220-240VAC, 50Hz / I
1850-2200W
1.7 litres
3
English
Publicidad
