Publicidad
Idiomas disponibles
Idiomas disponibles
SETTING UP YOUR HUMIDIFIER
Unpack the Humidifier
Keep this Owner's Manual for reference
Remove packaging materials. Locate Float Paddle and set aside. This is required for operation.
Remove twist tie and extend power cord. Plug Adapter Cord into the port on the back of the unit.
Place on a firm, level, water resistant surface a minimum of 12 inches (30 cm) from walls.
FLOAT PADDLE INSTALLATION - REQUIRED FOR HUMIDIFIER TO OPERATE
This humidifier uses a float system to regulate the water flow from the Tank to the Reservoir. The Float Paddle
must be properly installed for the unit to operate. If not properly installed, water may not flow into the Reservoir or
it may leak from the Base. The Float Paddle is designed to be easy to install and remove.
1. Remove Water Tank.
2. Line up Float Paddle with the dashed line float paddle shape on the bottom of the Reservoir.
Place paddle over brackets. The paddle can be gently placed in the brackets.
It does NOT snap-in, rather is simply set in place.
3. Replace Tank in Base.
1
CAUTION: IMPROPER PLACEMENT OF THE FLOAT PADDLE COULD RESULT IN LEAKING OR
WATER NOT FEEDING INTO THE RESERVOIR.
Hard Water and White Dust
High mineral content in your water, also known as hard water, may cause a white mineral residue to accumulate
on surfaces in the room near the humidifier. This mineral residue is commonly referred to as white dust. The
higher the mineral content (hardness) of your water, the greater the potential that an ultrasonic humidifier may
produce white dust.
White dust is not a result of a defect or flaw in the humidifier. It is a result of the amount of minerals suspended in
the water you are using.
To reduce white dust, use distilled water or the HDC500 Demineralization Cartridge (HDC500CV1 in Canada)
available through Consumer Relations; see back of this manual.
2
3
4
Publicidad
