AFG 4 x 2/3 GN Instrucciones Para La Instalación página 13

2.9 REVERSAL OF DOOR OPENING
In this oven series you can reverse the door opening also after installation, without asking for this option upon
the order of the oven. Proceed as follows:
Unscrew and remove the 2 screws indicated by the ar-
rows, that fix the door to the hinges, taking care to
support the door.
Disconnect the wiring connector for the cooking
chamber lighting.
Pull the door out of hinges and lay it over a flat surface
with the handle upwards.
Remove the drip pan under the door from position A
and screw it again upside down on position B.
The holes for the fixing of position B are protected by
rivets, that must be removed.
Unscrew the 2 hinges from position A and B and screw
them again in the foreseen holes for position A1 and
B1.
Unscrew the door lock from position C and screw it
again on position C1. The holes of positions A1 B1 and
C1 are closed by protection screws. Use the screws
protecting holes A1 B1 and C1 to close the holes of
positions A, B, C.
After you have removed the right hand side panel,
pull out the wiring for chamber lighting and let it pass
through the hole near hinge B.
Connect the wiring connector for chamber light-
ing.
Fix the door upside down to hinges A and B.
13
EN