Publicidad
Idiomas disponibles
Idiomas disponibles
Window Installation Instructions
6
INSTALL THE CASE
IN THE WINDOW
Cut the window sash seal to the window
A
width and stick the adhesive side to the
bottom of the sash.
Window sill
Window sash seal
B
Thread two type C bolts into the support
brackets.
Slide the case into the window and lower
the window behind the top mounting rail.
Position the brackets on the case bottom so
they will be near the outermost point on the
window sill. Attach the support brackets to
each side of the case bottom using 4 type A
screws on each side. The case should be
slightly tilted to the outside. Use a level;
about a 1/2 bubble will be the correct case
slant to the outside. Adjust the leveling bolts
to touch the sill.
Window sill
CAUTION:
conditioner in a window if the type C bolts
do not contact the window sill.
Type A screws
Type C bolts
Do not install this air
6
INSTALL THE CASE
IN THE WINDOW
Locate the 8 screw holes along the bottom
C
front edge of the case. Center the case, side-
to-side, in the window and mount it to the
window sill using 5 type B screws staggered
in the front and back rows if possible.
Type B
screws
Type B screws
D
Extend the left and right accordion panels to
the vertical window sashes and attach with
4 type B screws.
INSTALL THE SECURITY
7
BRACKET AND THE FOAM TOP
WINDOW GASKET
Attach the security bracket with a type B
A
screw.
B
Cut the foam top window gasket to the
window width.
C
Stuff the foam between the glass and the
window to prevent air and insects from
getting into the room.
13
(cont.)
Top mounting rail
Type B
screws
Publicidad
