Publicidad
Idiomas disponibles
Idiomas disponibles
Fitting instructions: Information for the technician
1
Open the BOA
pulley system by pulling the rotary
®
knob (clicking noise). Pull the two brace elements
apart until the entire rope is pulled out of the BOA
system.
3
Open the twist and click fastener on the chest
strap.
5
Guide the affected side of the arm through the
axillary strap and pull the shoulder pad onto the
roof of the shoulder. Pay attention to flush fitting
placement on the shoulder.
2
Remove the quick-release fasteners which connect
the shoulder pad and the arm pad.
®
4
Pull the axillary strap to its full length and attach it
again firmly.
6
Close the chest strap beneath the axilla via the
twist and click fastener and pull the belt tight using
the thumb loop. The thumb loop can be attached
to the chest strap using the Velcro surface on the
thumb loop.
EN
17
Publicidad
