Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
WEARING THE DEVICE
1. The carrying case allows you to easily take your iGo2 POC with you while on the
go. Simply place the POC in the case, and adjust the shoulder strap to the desired
length.
SILENCING ALARM CONDITION
To silence an audible alert during operation, simply press and
release the Alarm Silence button on the control panel. The
Alarm Silenced symbol will remain on the display until the
alarm condition is corrected.
STORAGE
When not in use, your device and batteries should be stored in a cool, dry location within the specified storage parameters (refer to Specifications).
• Do not store batteries haphazardly in a box or drawer where they may short circuit each other or be short-circuited by other metal objects.
• Do not store batteries longer than 1 year without recharge.
• Lithium-ion batteries can be stored from -4°F to 140°F (-20°C to 60°C) at up to 90% relative humidity.
• Recommendation: Store the battery below 77°F (25°C), low humidity, no dust and no corrosive gas atmosphere. Store fully charged if possible. Avoid storage in direct sunlight.
High temperature storage (above 104°F / 40°C), such as in a hot car, may degrade battery performance and reduce battery life. Low temperature storage may affect battery
performance.
The best battery charge conditions are within a temperature range of 32°F to 113°F (0°C to 45°C) at up to 90% relative humidity. If the battery temperature exceeds 113°F (45°C), the
device will not charge the battery. Charging will be resumed when the battery temperature drops to 111°F (44°C) or below.
LONG TERM STORAGE
Do not store batteries longer than 1 year without recharge.
NOTE– Using the POC more frequently will prolong sieve bed life. If the POC has been stored for an extended period of time, it may take up to 30 minutes of operation to recover
sieve beds to their full potential.
NOTE– Run the device for 20 minutes every 6 weeks while in storage for optimal performance.
EN - 10
POWER OPTIONS
Your iGo2 POC can be used on the 3 following power sources:
1. Battery Power – Your device must always have a battery installed to operate. The
HOT
WARNING
This area can emit hot
2. AC Power (for use at home or where standard AC power is available) – Attach the
exhaust gas. Do not
place near bare skin.
3. DC (car charger) Power
device will function correctly.
iGo2 POC will use battery power if no other power source is present. However, if AC
or DC power is connected, the device will run on that power source thus conserving
battery charge level. If the other power source is disconnected, the device will
automatically switch to battery power. The device will operate for a minimum of 3.5
hours at a setting of 2 at 20 BPM (breaths per minute) using a new fully charged
battery
universal AC Power Supply to the concentrator and an AC power outlet using the
AC Power Cord
a.
START YOUR VEHICLE.
NOTE– DO NOT leave the iGo2 or Power Supply plugged into the vehicle
without the engine running or attempt to start the vehicle while either is
connected to the vehicle. This may drain the vehicle's battery.
b.
Attach Power Supply to the device and to the vehicle accessory power port
using the DC power cord.
c.
Secure the iGo2 POC and Power Supply in your vehicle and make sure the
air inlet and exhaust vents are not blocked.
NOTE– Battery will not charge if plugged into power source less than 13.8V but the
A-125B
Publicidad
