Replacing Carbon Brushes; Optional Accessories - Makita 3601B Manual De Instrucciones

(A) to secure the trimmer guide in place. When adjusting
the guide roller up or down, loosen the wing bolt (C).
After adjusting it, tighten the wing bolt (C) securely.
1
2
3
4
005048
When cutting, move the tool with the guide roller riding
the side of the workpiece.
3
003701
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the rear cover.
1. Wing bolt (B)
2. Fine adjusting
screw
3. Wing bolt (A)
4. Trimmer guide
5. Wing bolt (C)
6. Guide roller
6
5
1. Bit
1
2. Guide roller
3. Workpiece
2
1. Limit mark
1
005049
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
Then install the rear cover with the screws.
005050
CAUTION:
Do not turn the tool on without the rear cover
•
installed in place.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Straight & groove forming bits
•
Edge forming bits
•
Laminate trimming bits
•
Straight guide
•
Trimmer guide
•
Templet guide 25
•
7
1. Screwdriver
2. Rear cover
1
2
1. Brush holder
1
cap
2. Screwdriver
2
or attachments
Only use accessory or
are