Install The Hardware; Prepare The Network Cable; Install The Wall Bracket - Axis Q1755-E Guia De Instalacion

Page 8

Install the hardware

The instructions below describe the installation of AXIS Q1755-E.

Prepare the network cable

If a cable other than the provided cable is used, you need to prepare a network cable with a gasket.
Gently force the cable through the gasket provided and attach a network connector. It may be
necessary to pierce a hole in the gasket with the supplied screwdriver.
Notes:
• Do not force the network connector into the gasket.
• Do not pierce the gasket with a knife or other sharp object.

Install the wall bracket

1. Use the supplied drill template to prepare a wall, ceiling, or pole for installation of the wall
bracket.
2. Route the network cable through the wall bracket, the rubber gasket should be on the bracket
adapter end of the wall bracket, see illustration on page 7.
3. Install the wall bracket on a wall, ceiling, or pole and make sure that the screws and plugs are
appropriate for the material (e.g. wood, metal, sheet rock, stone).
Notes:
• The weight of the camera is 3485 g (7.7 lb.) . Check that the material is strong enough to support this
weight.
• For more technical specifications, please see the User's Manual, available on the CD included in this
package, or from www.axis.com
AXIS Q1755-E Installation Guide