Descargar Imprimir esta página

Worx Nitro WG761E Manual Original página 16

Cortacésped a batería

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 54
Opening the LED headlight
Removing/emptying grass collection
bag
WARNING! Always check the
safety flap close the discharge
outlet before using. Never lift the
safety flap when the lawn mower
is being used without fitted grass
collection bag.
Storage
BATTERY STATUS (See Fig. I)
Light
ON/ Flash
One Red on
Two LED-lights
off
----------
One Red flash
Two LED-lights
off
16
Three Green on
----------
Three Green
flash
MULCHING MOWING TIPS
While mulching, your new mower is designed to cut the
grass clippings into small pieces and distribute them
back into the lawn. Under normal conditions, the mulched
grass will biodegrade quickly and deliver nutrients to the
lawn. Please review the following recommendations for
optimum mulching performance.
1)
Avoid mowing when the grass is wet from rain or dew.
Wet grass may form clumps which interfere with the
mulching action and reduce the runtime. The best time
to mow the grass is in the late afternoon when the grass
is dry and the newly cut area will not be exposed to
direct sunlight.
2)
For the best mulching performance, set the cutting
height to remove about one third of the grass blade
length, ideally no more than 40mm at one time. If the
lawn is overgrown, it may be necessary to increase the
cutting height to reduce the pushing effort and prevent
overloading the motor. For extremely heavy mulching,
it is advisable to first cut at a high cut height setting,
and then re-cut to the final cut height. Otherwise, make
Cordless Lawn Mower
See Fig. M
See Fig. N1,
N2
See Fig. O1,
O2
Status
Defective Battery
Battery Temperature
Protection
The temperature of battery
0
pack is less than 0
C or
more than 45
0
C
Fully Charged
Charging
narrower cuts and mow slowly.
3)
For the best performance, keep the mower housing
free of built-up grass. From time to time turn off mower
and wait for the blades to come to a complete stop.
Then Remove the safety key and turn mower on its
side. Using an object such as a stick, wipe out any
accumulation of grass around the blade area. Be careful
of the sharp edges of the blade. Ensure to clean the
blade area often when cutting wet or new grass and
every time after the machine is used.
4)
Certain types of grass or grass conditions may require
that an area be mulched a second time to fully disperse
the grass throughout the lawn. If cutting a second time,
it is advisable to cut perpendicular (across) the first cut
pattern. DO NOT CHANGE CUT PATTERN IN ANY WAY
THAT WOULD CAUSE MOWING DOWN A HILL.
5)
Change your cutting pattern from week to week. This
will help prevent matting and graining of the lawn.
6)
Do not mow on a slope that has an angle of greater
0
than 15
.
CUTTING AREA
The cutting area can be affected by several factors, such
as cutting height, lawn humidity, grass length and density.
Besides, starting and stopping the mower too many times
during operation will reduce the cutting area.
The table below gives the relationship between cutting
conditions and cutting area.
Cutting Height
Cutting off 8cm to 6cm
* Use with 4 fully charged battery packs. If batteries of
differing amp hours are used together, the product will
operate to the lowest common denominator.
TIPS:
1)
It is recommended to mow your lawn more frequently,
walk at normal pace, and not to start/stop the mower
too often during operation.
2)
For best performance, please ensure use 4 fully
charged battery packs at the same time and always cut
off 1/3 or less of the grass height.
3)
Walk slowly when cutting long grass, so as to have more
effective cutting and properly discharge the clippings.
4)
Avoid cutting wet grass, otherwise it will stick to the
underside of the deck and the clippings cannot be
collected or discharged properly.
5)
A higher cutting height shall be applied to new or thick
grass and it will extend the battery duration.
STORAGE (SEE FIG. O1, O2)
Stop the mower, and always remove the Safety Key and bat-
teries. Clean the exterior of the machine thoroughly using a
soft brush and cloth. Do not use water, solvents or polishes.
Recommend lot size
(maximum)
With 4*20V / 4.0Ah batteries
2
up to 1000m
*
EN

Publicidad

loading

Este manual también es adecuado para:

Wg761e.9