Publicidad
Idiomas disponibles
Idiomas disponibles
FR
Before installing the product, remove the unnecessary cord and disable any equipment not
needed for power operation.
ES
Choosing a safe location
Never install it in high and windy places, as the sunshade may drop and hurt people. The
PT
location for mounting your automation device: this location must allow for the automation
device to pick up the signals easily to ensure maximum sensitivity of the command box.
I T
Do not use it in places that have vibrations or impulsions.
In case of use of a command box, the electronics board must be set vertically and sheltered
EL
from the weather.
The installation can be made by non-professionals assuming the instruction is followed
PL
correctly. Should you have any trouble during assembly, please consult a qua
help.
UA
Please use all the screws and nuts correctly during installation as it is very dangerous if you
leave it loose.
RO
Be careful with y
EN
3. ELECTRICAL SAFETY
CAUTION: The installation must be conform to the regulation of the country.For your safety,
connection operation.
Before connecting the appliance to the power supply, check that the power supply voltage and
current rating corresponds with the power supply details shown on the appliance rating label.
A readily accessible disconnect device must be incorporat
with setup regulations.
Danger of electric shock! Do not attempt to repair the appliance yourself. In case of
malfunction, repairs are to be conducted by qua
T
ation of the design or con
manufacturer or his authorized representative may create a dangerous situation.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qua
For an inspection or maintenance of the electrical parts, the external blind shall be
disconnected from the energy supply in a reliable way.
ngers around moving parts of the product during installation.
What you will need: hardware not provided:
> Waterproof junction box (IP54)
> Cables
>
BATTERIES
ration of the equipment without consulting the
rsons in order to avoid a hazard.
82
(CR2450 3V)x 1
xed wiring in compliance
rsonnel only.
rson for
Publicidad
