Machine Components; Machine Setup - Nobles Frontier 608549 Manual Del Operador Y Piezas

OPERATION

MACHINE COMPONENTS

2
1
14
13
12
1. Solution Tank Lid
2. Recovery Tank Dome
3. Main Power Switch
4. Brush/Spray Switch
5. Circuit Breakers (under switchbox)
6. Recovery Tank Drain Hose
7. Brush/Vacuum Head Lift Lever
8. Power Cord Pigtail (120V Model)
9. Power Cord Storing Hook
10. Detachable Power Cord (120V Model)
11. 254 mm (10 in) Stair Climbing Wheels
12. Vacuum Head
13. Brush Housing
14. Spray Bar

MACHINE SETUP

1. Carefully check carton for signs of damage.
Report damages at once to carrier. The machine
is shipped fully assembled and is ready for
operation.
2. Remove solution tank lid and fill tank with 38 liters
(10 gallons) of hot water, 60°C (140°F) maximum
(Figure 1).
WARNING: Flammable materials can cause
an explosion or fire. Do not use flammable
materials in tank(s).
4
4
3
5
6
9
7
8
10
11
Home Find... Go To..
FIG. 1
NOTE: When using a bucket to fill tank, make sure it
is clean. Always use separate buckets when filling and
emptying machine.
3. Add a recommended cleaning solution. Follow
bottle's mixing instructions.
FOR SAFETY: When using machine, follow mixing
and handling instructions on chemical containers.
NOTE: If desired, hot water alone achieves excellent
cleaning results.
ATTENTION: If using powdered cleaning
chemicals, mix prior to adding.
4. Replace lid securely after filling.
5. Connect the detachable power cord to machine,
use cord restraint strap provided (120V Model).
6. Plug power cord into a grounded wall outlet
(Figure 2).
Grounded
3 Hole Outlet
Ground Pin
FOR SAFETY: Do not operate machine unless
cord is properly grounded.
FOR SAFETY: Do not operate machine with the
use of additional extension cords. Only use
manufacturer's cord equipped with machine
which has proper capacity and is grounded
(120V Model).
Frontiert Carpet Extractor (06–01)
(120V)