Machine Operation; Pre-Operation; Cleaning Carpets; While Operating - Nobles Frontier 608549 Manual Del Operador Y Piezas

MACHINE OPERATION

FOR SAFETY: Do not operate unless operator
manual is read and understood.
PRE–OPERATION
1. Vacuum carpet to remove particles and other
debris.
2. Inspect power cord for damage.

CLEANING CARPETS

1. Turn on main power switch.
2. Lower brush/vacuum head lift lever (Figure 2).
FIG. 2
3. To begin cleaning, hold down the brush/spray
button and push machine forward at a pace of
approximately 23 m (75 ft) per minute. For heavily
soiled areas, push machine at a slower pace
(Figure 3).
WARNING: Flammable materials or reactive
metals can cause explosion or fire. Do not pick
up.
FIG. 3
4. Release button at end of path and continue to
push machine forward to pick up excess solution.
5. After cleaning, perform the daily maintenance
instructions.
NOTE: Allow up to one hour for carpet to dry. Use air
movers to reduce drying time.
Frontiert Carpet Extractor (06–01)
Home Find... Go To..

WHILE OPERATING

1. If necessary, adjust brush height to accommodate
type of carpet (See ADJUSTING BRUSH
HEIGHT).
2. Overlap each path by 51 mm (2 in).
3. Work away from wall outlet and power cord to
prevent cord damage.
4. When turning machine around, release
spray/brush button, push down on handle and
pivot machine on rear wheels.
5. Check for excessive foam buildup in recovery
tank. Use a recommended foam control solution to
prevent motor damage.
ATTENTION: Foam will not activate the float
shut-off screen. Motor damage due to foam or
water is not covered by warranty.
6. When the float shut-off screen is activated, water
pickup will stop. Drain recovery tank at this point
and refill solution tank (See DRAINING TANKS).
7. If brush or vacuum motor should stop, circuit
breaker may have tripped. Shut off machine,
unplug power cord and check for any obstructions.
Let motor cool and manually reset circuit breaker
button, located on switch box.
8. Raise brush/vacuum head when transporting
machine to draining area.

CLEANING WITH ACCESSORY TOOLS

See Options.
1. Disconnect vacuum hose from recovery dome and
connect accessory vacuum hose (Figure 4).
2. Connect accessory solution hose to quick coupler,
located in front of handle (Figure 4).
FIG. 4
3. Attach desired accessory tool to hoses.
4. Turn on main power switch.
OPERATION
5