VOX electronics SJ-368 Manual De Usuario página 10

Using the Slow Juicer
1. Once all parts are securely in place, connect the power cord to an approved power source.
2. Place one of the collectors under the pulp ejector, and either a glass or the other collector
under the juice spout.
3. The Slow Juicer has 3 settings (Figure 6)
a. ON- this starts the motor for juicing.
b. OFF- this stops operation.
c. REV- this moves the Auger in the opposite direction.
4. Before placing food in the Slow Juicer, make sure all foods have been thoroughly washed,
if food has to be peeled, there is no need to wash. Also make sure to cut all foods to an
appropriate size so it easily fits into the Food Chute, we recommend no more than 3-inch
pieces. *Please make sure to remove any hard seeds or pits, such as cherry or plum pits, as it
will not process in the juicer and can damage the Auger.
5. When placing any food in the Slow Juicer, the Auger will automatically pull in the food,
and begin juicing immediately. DO NOT push, force, or overstuff the unit. The Pusher
provided with the Slow Juicer is only to use when food obstructs the inside of the Food
Chute.
6. It is best to insert all food at a slow pace, allowing all pulp to be extracted from the fruit or
vegetable completely.
7. Reminder: turn off the Slow Juicer when juicing is complete. Do not run the Slow Juicer
without any food inside the unit as this could overheat the motor.
8. The Slow Juicer has a unique cleaning process when switching between different types of
juices. To clean, simply place one of the collectors under the juice spout and pour water
though the Food Chute while the unit is on. This will rinse out most of the remaining residue
from your last juicing. When the water from the slow juicer begins to run clear, that is an
indication the unit is clean and ready to make a new juice recipe.
NOTE: This process is not an alternative to a complete cleaning of
each disassembled part.