Makita GA041G Manual De Instrucciones página 23

MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
COMBINATION OF APPLICATIONS AND
ACCESSORIES
Optional accessory
CAUTION:
Using the tool with incorrect guards can cause risks as follows.
• When using a cut-off wheel guard for facial grinding, the wheel guard may interfere with the work-
piece causing poor control.
• When using a grinding wheel guard for cutting-off operations with bonded abrasive wheels and dia-
mond wheels, there is an increased risk of exposure to rotating wheels, emitted sparks and particles,
as well as exposure to wheel fragments in the event of wheel burst.
• When using a cut-off wheel guard or grinding wheel guard with a wheel-type wire brush with a thick-
ness greater than the maximum thickness as specified in "SPECIFICATIONS", the wires may catch on
the guard leading to breaking of wires.
• Use of dust collecting wheel guards for cutting-off operations in concrete or masonry reduces a risk
of exposure to dust.
► Fig.40
-
1
2
3
4
5
6
7
8
9
10
NOTE: *1 In some European countries, when using a diamond wheel, the ordinary guard can be used instead of the
special guard covering the both side of the wheel. Follow the regulations in your country.
NOTE: *2 Clip-on cutting wheel guard attachment is not available in some countries such as Korea, Taiwan, and
mainland China. For more details, refer to the instruction of the clip-on cutting wheel guard attachment.
Application 100 mm (4") model
-
-
Grinding / Sanding
-
Cutting-off
Wire brushing
Wire brushing
-
-
Cutting-off
Air vent cleaning
The tool and its air vents have to be kept clean.
Regularly clean the tool's air vents or whenever the
vents start to become obstructed.
► Fig.38: 1. Exhaust vent 2. Inhalation vent
Remove the dust cover attachment from inhalation vent
and clean it for smooth air circulation.
► Fig.39: 1. Dust cover attachment
NOTICE:
Clean out the dust cover attachment
when it is clogged with dust or foreign matters.
Continuing operation with a clogged dust cover
attachment may damage the tool.
115 mm (4-1/2") model
Side grip
Wheel Guard (for grinding wheel)
Depressed center wheel / Flap disc
Wheel Guard (for cut-off wheel) *1
Abrasive cut-off wheel / Diamond wheel
-
Wire cup brush
Clip-on cutting wheel guard attachment *2
Dust collecting wheel guard for cutting-off
Diamond wheel
23 ENGLISH
125 mm (5") model
Wire wheel brush