Cleaning Tips - ProBreeze PB-H02 Manual De Instrucciones

Setting the Timer
1.
Plug in the heater.
2. Set the power and temperature to the desired settings.
3. Turn the dial clockwise to set the clock to the current time of the day.
4. Push the segments outwards for the period you want the heater on. For example,
the diagram above shows the heater will turn on between 1AM to 3AM (Fig.2).
5. Push the timer switch to the clock symbol.
6. Once you have set the segments for the desired heating period, the heater will
cycle on and off according to these settings.
7. Once unplugged, the heater timer will stop and will need to be reset.
Note: When you first use the heater, all 15 minute segments should be inwards. To
begin using the timer, push the segments outwards that represent the time of the
day you want the heater to work. The heater will switch off again after that period
has elapsed.

CLEANING TIPS

- Clean the exterior surface of the heater by wiping it with a soft, damp cloth.
- Store the heater in a clean, dry place when it is not in use.
Caution:
- Allow the heater to completely cool before handling or cleaning it.
- Ensure the heater is in the "O" OFF position and the power cord is unplugged
from the electrical outlet before cleaning the heater.
- Do not allow water or other liquids to run into the interior of the heater, as this
could create a fire and/or electrical hazard.
- Do not use any abrasive cleaners or solvents, as heater damage will occur.
English | 6