Descargar Imprimir esta página

identités 822013 Manual De Instrucciones página 17

Publicidad

Idiomas disponibles

Idiomas disponibles

When the temperature is below -20°C or above 55°C, do not use the transfer chair.
If the product is removed from the -20°C storage environment, it should wait for two hours at room temperature, and
can be used after drying.
Please charge it before using it for the first time, insert the most of the charger into the charging port of the battery, and
wait for the charger indicator light to turn green.
When the ambient temperature is below 0°C, please do not charge it to avoid damaging the battery and causing injury.
Please check the packaging for damage before unpacking, in case you need to repair or exchange it. If the original
packaging is missing, returns will not be accepted.
The caregiver must have the physical, mental and flexibility ability to operate the controller safely, not be visually
impaired and be able to read the instructions correctly. When using for the first time, please practice several times
without a passenger.
OPERATING INSTRUCTIONS
The transfer chair is suitable for use in homes, hospitals, nursing homes and on other flat roads. Do not stop the chair
on a slope. The transfer chair can only be moved or used by the carer, the patient sitting in the chair is not allowed to
operate it.
This transfer chair is equipped with four wheels with brakes, before moving it, please make sure that the four brakes are
released, after reaching the target position, please press the brake pedals to lock the wheels.
After inserting the battery, press the up or down button to turn on the transfer chair. If the indicator does not light up,
please check if the battery is in place. When used for the first time, the transfer chair should be "re-initialised" before
use. Please refer to chapter 4 "Installation and Commissioning" and follow the guide.
Please refer to the picture guide in Chapter 5 "User's Guide" to help the patient sit or stand up from the chair.
Before moving, please ensure that the backrest safety belt and the latch are locked, that the patient is seated properly
and that the safety belt is fastened.
When transferring the patient to the destination, the caregiver should lower the chair to an appropriate height while
ensuring safety to avoid injury or property damage. When using the lowering function, please stop in advance when
approaching the target object (sofa, bench, bed or toilet, etc.), and then press the lowering button briefly to adjust the
height gradually. If the target object is a hard object, avoid direct contact between the transfer chair and the object
(leave a 1-2 cm gap).
The waterproof level of the transfer chair is IP25, it has anti-splash function. It can be used in the bathroom shower.
The transfer chair's four-wheel brake switch must be locked before bathing to prevent slipping. This transfer chair cannot
be used by immersing it in water. If the bath is not well drained and water accumulates up to the height of the battery
bar, please stop the shower and immediately move the chair to a place where there is no water. You can continue to
use the chair once the water has drained.
The cushion of this chair is not waterproof, please remove it before entering the bathroom.
If the panel is damaged, there is a risk of water infiltration, please do not use it in a bathroom, contact the dealer or
manufacturer for repair.
There is a bed tray mounting frame under the seat back for quick installation of the bed tray.
The life span of this transfer chair in clinical use depends not only on the structural strength, but also on the conditions
of use, user habits and proper maintenance.
DMI-F-07_Annexe 2_Notice.2
17

Publicidad

loading