Publicidad
Idiomas disponibles
Idiomas disponibles
Searching a track by listening
to track passages — ZAPPIN™
While playing back short track passages in a
USB device in sequence, you can search for a
track you want to listen to.
ZAPPIN mode is suitable for searching for a
track in shuffle or shuffle repeat mode.
1
Press (ZAP/SHUF) during playback.
After "ZAPPIN" appears in the display,
playback starts from a passage of the next
track.
The passage is played for the set time, then a
click sounds and the next passage starts.
Track
(ZAP/SHUF)
pressed.
2
Press the multi-way encoder or
(ZAP/SHUF) when a track you want to
listen is played back.
The track that you select returns to normal
play mode from the beginning.
To search a track by ZAPPIN mode again,
repeat steps 1 and 2.
In the case of "SensMe™
channels" playback
If the track being searched is transferred by
"Content Transfer," the most melodic or
rhythmical sections* of tracks are played. For
details on the SensMe™ function, see page 15.
* May not be detected correctly.
Tips
• You can select the playback time from about 6
seconds/15 seconds/30 seconds (page 28). You
cannot select the passage of the track to playback.
• Push the multi-way encoder left/right in ZAPPIN
mode to skip a track.
• Push the multi-way encoder up/down in ZAPPIN
mode to skip album.
24
The part of each track to
playback in ZAPPIN mode.
Sound Settings and Setup Menu
Changing the sound settings
Adjusting the sound
characteristics
1
During reception/playback, press the
multi-way encoder.
2
Rotate the multi-way encoder until the
desired menu item appears, then
press it.
3
Use the multi-way encoder to select
the setting, then press it.
4
Press
(BACK).
The setting is complete and the display
returns to normal reception/play mode.
The following items can be set:
The operation of the multi-way encoder will
differ depending on the items.
: Push the multi-way encoder up/down
: Push the multi-way encoder left/right
: Rotate the multi-way encoder
EQ7 Preset (page 25)
EQ7 Parametric Tune (page 25)
Listening Position Front/Rear (page 25)
Listening Position Subwoofer (page 26)
Listening Position Custom Tune (page 26)
Fader & Balance
Front/Rear/Center (
Adjusts the relative level.
Right/Left/Center (
Adjusts the sound balance.
Subwoofer Tune & LPF
Phase (
)
Selects the phase: "Normal," "Reverse."
FREQ (
)
Selects the subwoofer cut-off frequency:
"50Hz," "60Hz," "80Hz," "100Hz," "120Hz."
Slope (
)
Selects the LPF slope: "1," "2," "3."
Subwoofer Level (
Adjusts the subwoofer volume: "+10 dB" –
"0 dB" – "–10 dB."
("– ∞" is displayed at the lowest setting.)
HPF
FREQ (
)
Selects the cut-off frequency: "off," "50Hz,"
"60Hz," "80Hz," "100Hz," "120Hz."
Slope (
)
Select the HPF slope: "1," "2," "3."
DM+ Advanced (page 26)
Rear Bass Enhancer (page 27)
)
)
)
Publicidad
