Deleting A Job; Retrieving A Job - Castolin Eutectic TotalArc 3000 Manual De Instrucciones

- Briefly press down the MEM button
menu

Deleting a Job

A job that has been stored to a program location can also be
deleted again. To delete a job, proceed as described below:
- Briefly press down MEM button
The first vacant program location for the Job is indicated.
- With the Program button
(Indicator CLEAR lights up)
- Press up and hold the MEM button
reads "dEL" - the job is deleted.
"nPG" appears on the left-hand display to indicate that the
job is now deleted. Release the MEM button
- Briefly press down the MEM button
menu
to exit from the job
to change to the job menu.
, select the job to be deleted
. The left-hand display
.
to exit from the job

Retrieving a Job

Once programmed, all jobs can be retrieved in Job Mode. To
retrieve a job, proceed as follows:
- With the Process button
- With the MIG/MAG mode button
mode (MEM) - the last job will be displayed
To view the settings programmed in this job, use the
Parameter Selection buttons
operating mode and the welding torch operating mode of the
stored job are displayed.
By pressing the MEM button
button at the same time the corresponding program
("characteristic") will be displayed from which the job was
created at first. Press the MEM button
- Using the Program button
N.B.! When you retrieve a job directly from the power source,
you can also select vacant program locations (symbolised by "-
- -")
- Start welding - during welding you can always change to
another job without interruption.
- When you change to another program, this finishes Job
Mode.
49
, select MIG/MAG welding
, select the MIG/MAG job
and . The MIG/MAG
and the MIG/MAG mode
to exit.
to select the desired job