Publicidad
GB
MONTAGEANLEITUNG
GSX-8S 2023-
Mounting the windscreen on the motorcycle
Place the motorcycle on a flat surface.
1.
Remove the two original mounting screws (P1).
2.
Mount the MRA retaining plates [11547] on the motorcycle with the original mounting screws
3.
and the washers [11036] (P2, P3). Do not tighten the screws fully!
Plug the elastic nuts [10629] into the retaining plates (P4) and attach the MRA windscreen to
4.
the motorcycle with the fillister head screws [10554] and plastic washers [10635].
Align the windscreen with the retaining plates and tighten all screws fully.
5.
Fit the edge protection as shown in image 5 and secure it in place at each end
6.
using the clamping sleeves supplied.
Check all screws for tightness after installation and subsequently at regular intervals, and
retighten if necessary. Clean the windscreen using a sponge, water and neutral soap.
Solvents, alcohol and petrol will damage the windscreen.
MRA-Klement GmbH
Siemensstr. 6 · D-79331 Teningen
Phone +49 7663 9389 - 0 · info@mra.de
5
Publicidad
