Publicidad
Idiomas disponibles
Idiomas disponibles
2. HOW TO USE
PARTS
1. Front guard
2. Fan blade
3. Guard nut and screw
4. Rear guard
5. Motor axis
6. Motor housing
7. Oscillation control
8. Speed control switches
9. Switch box
10. Motor support fixing screw
11. Upper tube
12. Fixing nut
13. Lower tube
14. Base
ASSEMBLY
The only tool needed for this assembly
procedure is a Philip screwdriver.
1. Assembling the cross-bar feet first of
all (bars A and B), loosen and remove
the four screws from the bars. Be sure to
align the four holes on the flange at the
same time. Align the projection on the
flange through the extra hole on bar A, then tighten the four screws and insert the base
cap down over the feet.
2. Insert the switch box on the inner pipe and fix it securely.
MAIN BODY ASSEMBLY
1. Motor
3. Guard lock nut
5. Blade cap
2. Rear guard
4. Blade
6. Front guard
7. Screw
Publicidad
