Black and Decker HNVC215B Manual De Instrucciones página 7

Fig. E
hnVC215B/hnVC220B
Fig. F
hnVC220BCZ00W
Bag filter and pre-filter (Fig. G, H)
HNVC220BCZ00W
The bag filter and pre‑filter can be separated to allow for
better cleaning.
Twist the bag filter to separate it from the pre‑filter.
Fig. G
Fig. H
12
Cleaning the dust bowl and filter
The dust bowl and filter can be washed in warm soapy
water.
1. Make sure the filters and the dust bowl
installing.
Accessories (Fig. I)
Your hand vac may be supplied with some of the following
accessories:
- A brush tool 5 for furniture and stairs.
1. A crevice tool 13 is built into the dust bowl and can be
extended as shown in Figure I by pulling the extension
piece until it locks into position.
10
3
11
12
11
3 are dry before
2. To store the crevice tool, press the release button
and push the crevice tool
shown in Figure I.
Fig. I
13
14
D
Fitting (Fig. J)
1. Insert the appropriate accessory into the front of the
dust bowl 4 as show in Figure J.
2. Make sure the accessory is fully pushed in.
Fig. J
4
7
Replacing the filters
The filters should be replaced every 6 to 9 months and
whenever worn or damaged. Replacement filters are
available from your BLACK+DECKER dealer.
Visit www.blackanddecker.com to locate dealers.
Remove the old filters as described in Cleaning the Filters.
•
Fit the new filters as described in Cleaning the Filters.
•
(cat. no: HNVCF10)
These fit all units. When these filters reach the end of their
lifespan they must be disposed of at a local recycling center.
MAINTENANCE
Use only mild soap and damp cloth to clean the vac. Never
let any liquid get inside the vac; never immerse any part of
the vac into a liquid.

WARNING:
completely dry before using it.
iMPORTAnT: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (other than those
listed in this manual) should be performed by authorized
English
14
13 into the dust bowl as
Make sure the vacuum is
5