ims PRO IMS MULTIWELD 160M Manual Del Usuario página 16

MACHINE SUPPLIED WITH
3 m
2 m - 16 mm²
2 m - 16 mm²
POWER SUPPLY
The MULTIWELD is supplied with a 16A plug type CEE7/7 and must be connected to a 230V single phase power supply (50-60 Hz)
with three earthed wires.
The absorbed effective current (I1eff) is displayed on the machine, for optimal use. Check that the power supply and its protection
(fuse and/or circuit breaker) are compatible with the current needed by the machine. In some countries, it may be necessary to
change the plug to allow the use at maximum settings.
While under intensive use (superior to the duty cycle) the thermal protection can activate, in that case, the arc switches off and the
thermal protection indicator switches on.
CONNECTION ON A GENERATOR
The machine can work with generators as long as the auxiliary power matches these requirements :
- The voltage must be AC, always set as specified, and the peak voltage below 400V,
- The frequency must be between 50 and 60 Hz.
It is imperative to check these requirements as several generators generate high voltage peaks that can damage these machines.
USE WITH EXTENSION CABLES
All extension cables must have an adequate size and section, relative to the machine's voltage.
Use an extension that complies with national safety regulations.
MULTIWELD 160M
MULTIWELD 200M
DEVICE PRESENTATION (FIG. I)
1- Reel support
2- Back cable support
3- Digital displays
4- Adjustement of welding settings
5- European standard torch connection
6- Polarity reversal cable
7- Earth clamp connector
INTERFACE PANEL (FIG. VI)
1- Overheat/Overcurrent indicator
2- Voltage display
3- Current display
4- Green light «ON»
SWITCHING ON
The ON/OFF switch is located at the back of the machine. Press the switch on the «I» position to start the generator. This switch
must not be turned off (to «O») while welding. When the machine is powered, the ON LED lights up (FIG VI - 4).
16
MULTIWELD 160M / 200M
MULTIWELD 160M MULTIWELD 200M
063464 066786
Input Voltage
230 V - 1~
230 V - 1~
The accessories supplied with the MULTIWELD
generator may only be used with this product.
Section of extension cable
1.5 mm²
2.5 mm²
8- Torch support
9- Gas connector
10- On/off switch
11- Power supply cable
12- Bottle support (max 1 x 4m
13- Plug 36V AC for gas preheater
14- Storage area
15- Switch MIG/ MMA
5- Welding arc dynamic adjustment
6- Wire speed adjustment (MIG) / Current setting adjustment (MMA)
7- Voltage setting adjustment
bottles)
3
EN