Stainless steel surfaces
Do not use a steel-wool pad or abrasive cleaners on stainless steel surfaces.
Abrasive pads and cleaners will scratch the surface and damage the surface
WARNING
finish.
To prevent any discolorations
and/or grease stains, we
recommend cleaning and
removing any spills, spots, and
grease from the range after each
use.
1. Wipe off any spills with a damp,
soft cloth.
2. Apply an approved stainless steel
cleaner to a damp, clean cloth or
paper towel. Clean a small area
carefully following the instructions
on the cleaner. Stainless steel
should always be cleaned with
the grain in the stainless steel, if
applicable.
3. Dry and buff with a clean, dry, soft
cloth.
4. Repeat steps 2 and 3 as necessary.
Do not spray any type of cleaner into the manifold panel holes. Within these
holes are ignition switches which carry the current that lights the surface
WARNING
burners. Spraying into them could damage the range.
oven racks
•
If the racks are left in the oven during a self-cleaning cycle, their color will turn
slightly blue and the finish will be dull. After the self-cleaning cycle is complete
and the oven has cooled, rub the sides of the racks with wax paper or a cloth
containing a small amount of oil. This will help the racks glide more easily into
their tracks.
•
Gliding racks may be cleaned by hand with an abrasive cleaner or steel wool.
During cleaning, be careful not to allow water or cleaner to enter the slides on
the sides of rack.
•
Do not clean in a dishwasher.
•
If the rack becomes hard to remove or replace, lightly wipe the oven
rack guides with cooking oil. Do not wipe cooking oil on the slides.
•
If the rack becomes difficult to slide, the rack may need to be
lubricated using Graphite Lubrication.
•
To order Graphite Lubrication, call our customer center at
1-800-SAMSUNG (726-7864) or visit our homepage (www.samsung.
com/us or www.samsung.com/ca) and reference DG81-01629A.
•
If you want to buy directly, visit our on-line parts distributor at http://
www.samsungparts.com/Default.aspx.
60_ maintaining your appliance
Stainless steel
surfaces