Set Alarm - Medisana CardioCompact Instrucciones De Manejo

GB 3 Getting started

3.5 Set alarm

•
Adjust the display tilt angle in that way, that the marking of the tilt
mechanism
•
Press and hold the SNOOZE-button
seconds, until the alarm state of the first alarm
or OFF).
Press the MEM-button
can select ON (activates alarm) or OFF (deactivates alarm).
•
Press the SNOOZE-button
•
Follow the same steps (MEM-button
to continue with the next value) to enter the correct values
1
ton
for hour and minute.
•
After that, you may enter a second alarm time
same scheme.
•
You may leave the alarm setting mode at any time by pressing
the START-button
button the device automatically leaves the alarm setting mode.
•
If the batteries are removed, these values are lost and need to be
input again.
30
3
indicates "Travelling clock mode".
7
6
. After approx. 1 minute without pressing any
NOTES:
- The alarm only will be effective in Travelling
clock and blood pressure measurement modes
(not in OFF mode).
- The alarm settings are only referring to the
regular clock - even if a second time zone
has been set according to chapter 3.4 Set date
and time.
- Press "MEM"
alarm or press the "SNOOZE"-button
device will alarm again after 10 minutes.
- If no button is pressed within 50 seconds
during alarming, the alarm will be paused and
will alarm again after 10 minutes. If still no
button is pressed after 5 of the procedures, the
alarm will be cancelled.
1
to change the state of the alarm. You
1
to continue with the next step.
7
to adjust, SNOOZE-but-
7
or "START"
for at least approx. 2
flashes (ON
w
w
according to the
6
to stop the
1
and the
p