Publicidad
Idiomas disponibles
Idiomas disponibles
3
A.
Optional Extension
Kit Available -
RP72604
C.
5
6
Slide O-ring (1) over cartridge and the
A.
bonnet nut (2). The O-ring,
which acts as a spacer to steady the
sleeve, should rest behind the
bonnet nut. Note: Depending on the
location of valve within the wall and
wall thickness, an optional extension kit
(RP72604) can provide
an additional 1 3/4" of wall thickness.
If your model requires a spacer (3), install
B.
it into sleeve (4). Slide the sleeve over the
cartridge, body and O-ring. Ensure sleeve
is properly positioned over the front of
cartridge.
C.
Secure the escutcheon (5) to the rough
(2) with the 2 screws provided (6). Do not
overtighten escutcheon screws.
D.
For all models with an axial screw on top
of the handle blade, remove the top button
(7) from the handle (if already assembled)
by pulling straight up. Select legacy
models have a plastic insert (8) inside the
bottom of the handle. For those models,
verify plastic insert is inside the handle.
Make sure valve is in the full cold position
(to the right) and align lever of lever
handle models to the cold position on the
escutcheon and press handle onto valve
stem. Secure handle with screw provided
and press button back into top of handle.
2
1
2
4
B.
4
D.
7
8
For all other models which use a set screw
that comes in from the side of the handle
base, look inside the bottom of handle to
make sure the plastic insert (8) is in place.
Make sure valve is in the full cold position
and align lever of lever handle models to
the cold position on the escutcheon and
press handle onto valve stem. Secure
handle with set screw provided and install
set screw cover (if included).
5
3
102224 Rev. B
Publicidad
