BTI PROFILINE -NTS 20 A Manual De Montaje página 10

2. Prior to use.
Please read these instructions carefully as they contain
important information concerning use, safety, maintenance
and care. Keep these operating instructions in a safe place
and ensure that they are passed on to any possible sub-
sequent owner. Subject to changes of design and configura-
tion without previous notification.
3. Only use original accessories.
Paper filter bag FB 25
for 25-l container;
1 set of 5
Filter cassettes FK 4300
Cellulose material
1 set of 2
Filter cassettes FKP 4300
Polyester material
1 set of 2
For other optional accessories see our Accessories List or
ask for the corresponding information.
4. Fields of application.
For wet and dry vacuum cleaning. Not suitable for
vacuuming health hazardous dusts. The vacuum cleaner with
socket and ON/OFF automatic switching system is intended
for the connection of electric tools.
5. Setting into operation.
When unpacking, check that the appliance is complete and
that there is no transport damage.
Order No. 01 96 19
Order No. 01 96 18
Order No. 41 60 69
5.1 Electrical equipment.
The appliance is switched ON/OFF with the switch
1
fig. 1 on the top section
automatic or vibration mode.
O = Suction >OFF<
I = Suction >ON< (manual operation)
A = Ready for ON/OFF automatic switching system (the
vacuum cleaner is switched on and off by the
connected electric tool).
R = Filter cleaning function; in this setting the vibrator will
operate for 7 seconds after which it will be automa-
tically turned off.
AR = Appliance version featuring "AR" can be operated as
described under "A" except that automatic filter
cleaning (as described under "R") is turned on when
the volume flow display lights up.
2
The power socket b is intended for the connection of an
electric tool.
WARNING! An electric tool must be switched off when
it is connected. The socket is always live when the plug is
inserted in a mains socket, irrespective of the switch posi-
tion. In the "0" switch setting, the socket can be used for an
extension line (e.g. for a light).
Connected load: Suction unit and appliance max. 16 A
On appliances featuring two power sockets, the socket for
automatic switching is identified by an "A".
Appliances with an electronic suction force control feature
2
a rotary knob d with which the suction force can be
adapted to the object that is being cleaned.
The vibrating device should be activated (switch position R)
at the latest when the volume flow display
light) lights up or when the suction power decreases.
The suction openings of electric tools are not
standard. Consequently, an adapter (rubber nozzle) 582627
is available that can be shortened to fit the given electric
tool. With electric tools that have a very small suction
opening the volume flow display
manently illuminated during operation because the volume
flow is small. However, bypass motor cooling ensures that
no problems can arise when operating continuously under
these conditions. Such appliances should be operated in the
"A" switch setting and not "AR".
2
a (see
of the appliance), or switch to
2
c (warning
2
c may remain per-
11