3M 26878 Manual Del Propietário página 11

4. Turn until tight. Insert 3M™ PPS™ Series
2.0 Spray Cup System sealing plug prior to
shaking or sealing.
5. Attach spray gun to filled 3M™ PPS™ Series
2.0 Spray Cup System cup.
Note: Prior to painting, users are expected to
be appropriately grounded (by either shoes or
heel straps) and should wear static-dissipative or
static-conductive gloves.
Adjusting the Fan Pattern Size
The fan size is regulated by the fan adjustment
knob. The spray gun in the kit is preset in the
closed position (gently turn the fan adjustment
knob clockwise to verify; knob should not move).
Next, turn the knob counter-clockwise 2 rotation.
The fan adjustment will allow you to spray from a
small round to a full fan pattern.
Adjusting the Fluid Flow
The fluid flow can be adjusted by using the fluid
needle adjustment knob. The spray gun in the
kit is preset in the closed position (pull trigger
to verify; there should be minimal fluid needle
movement). To allow fluid flow, gently turn the
fluid needle adjustment knob counter-clockwise
4 full turns. These adjustment procedures will
serve only as a starting point. Fine tuning of
these adjustments will be based on your material
and technique.
The spray pattern can be changed from vertical
to horizontal by rotating the air cap a 1/4 turn.
HORIZONTAL PATTERN
VERTICAL PATTERN
9 9
Fan Adjustment
Knob
Fluid Needle
Adjustment
Knob