3M 26878 Manual Del Propietário página 15

Fluid Hose to Atomizing Head Connection
& Disconnection
1. With atomizing head securely locked on
frame, align connector wings parallel to
needle or front-to-back.
2. Slide connection over the spout of the
atomizing head and push the connection
onto the atomizing head.
3. Twist the connection while continuing to
push upward until the connector bottoms
out on the atomizing head as shown in the
fully connected image below.
Removing the Pressure Fluid Hose
Connector from Gun
1. Remove retention pin from connector
bracket holes
2. Remove bracket from air inlet fitting.
3. Twist the connection while gently pulling
downward.
13 13