SUHNER ABRASIVE LWE 10-TOP Documentación Técnica página 20

1. N
1.1 g
enerAl notes on sAfety
This operation manual is applicable for the machine LWE
10-TOP.
The machine may only be handled by personnel
who are qualified.
1.2 u
se of the mAchine for PurPoses for
which it is intended
The machines are intended for the purpose of cutting,
roughing and brushing of metal and stone materials.
1.3 i
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
declArAtion of conformity
Translations of the «EG-Koformitätserklärung (Original)».
Otto Suhner GmbH, Trottäcker 50, D-79713 Bad Säckin-
gen, hereby declares under sole responsibility that the
product with the serial or batch no. (see reverse side) com-
plies with the requirements under the Directive 2006/42/
EG. Applied standards: EN ISO 12100, EN ISO 11148.
Document Agent: T. Fischer. D-Bad Säckingen, 10/2019.
T. Fischer/Managing Division manager
2. C
2.1 P
rior to tAKing the mAchine into serVice
Si raccomanda aria compressa oleosa(see
also air quality under section 2.3). Ob-
serve national regulations.
2.1.1 f
itting of hose couPling
Fitting of hose coupling inside diameter min. 7mm (avail-
able as optional accessory, item no. 90805700).
20
S
oTES oN aFETy
ommISSIoNINg
2.2 t
AKing the mAchine into serVice
2.2.1 t /t
urn on urn off
Tilt lock forward and press lever on plastic sleeve. Releas-
ing the lever will shut the machine down.
2.3 r
Ating dAtA
Pressure
Power output
Air consumption full load EN ISO 15744
Air consumption at idling EN ISO 15744
Setting oiler idle
No-load speed
Max. wheel diameter
Grinding spindle thread
Sound pressure level EN ISO 15744 79dB(A), K=3dB(A)
Vibration EN ISO 28927-12
Air quality DIN ISO 8573-1
Weight
2.4 o
PerAting conditions
Temperature range during operation: 0 to +40°C
Relative air humidity: 95% at +10°C not condensed
3.
haNDLINg
3.1 P
rotectiVe deVices
The machine may only be operated with
the safety guards and the additional han-
dle fitted!
max. 6.3bar
600W
1.05m /min
3
1.3m /min
3
about 5-6 drops/min
10000min
-1
115mm
M14 / 5/8"
4.9m/s , K=1.6m/s
2 2
3/4/4
1.600kg
/ o
PERaTIoN