Publicidad
Idiomas disponibles
Idiomas disponibles
Insert cables through the rear of the Joey 10
Charging Station.
Ensure the excess device cable length is bundled
neatly in the rear of the Joey 10 Charging Station.
Re-do the screw inside the Joey 10 Charging Station
to secure down the top charger cover panel.
"Snap" the device dividers into place.
Sectional side view:
Rear cavity for excess cable
INSTRUCTION MANUAL
Pull the cables from within the Joey 10 Charging
Station to the desired length through the rubber
cable holder.
Replacing the charger panel cover:
1. Insert the front side first under the flap.
2. Then the tab side at the rear and slide in.
Insert and install the device dividers.
Top edge first.
2
1
Publicidad
