Makita P-54190 Manual De Instrucciones página 17

Fixing by means of the quick release fastener support
In order to brace the drill stand by means of the quick release fastener
support, the distance to the opposite wall must be between 1.7 and 3 m.
H
G
Warning! It is important that the drilling stand is firmly connected to the
surface. If not fixed correctly, injuries to the operator or damages to the
drilling unit may be the caused. Uncontrolled movements during drilling
will cause the drill bit to hit the surface to be drilled, which may lead to a
chipping of the segments. The drill bit might also tilt in the bore hole
which consequently will damage it.
Fixing the core drill tool
Setting up of the mounting plate
Position the drilling stand. Position the quick release fas-
tener support as close as possible behind the support on
the base of the stand. Fix the stand by turning crank (G)
clockwise. Secure in position by means of the appropriate
bolt (H).
Move the tool mount with the attached core drill
tool upwards until it locks in the final position.
Use the turnstile to open the locking device of
the mounting plate. Remove it and connect it to
the core drill tool as described subsequently.
The tool is supplied with a mounting plate, a 10
mm fitting key and 4 hexagon hollow head plugs
M8x20. The mounting plate is attached to the
tool with the fitting key so that the coupling on
the mounting plate is on the same side as the
gear change of the engine. Then the 4 plugs are
inserted and torqued tightly.
16