Publicidad
Idiomas disponibles
Idiomas disponibles
Technical specifications
Input Rated Capacity
No. of Phases
Open Circuit Voltage
Current Range
Type of Cooling
WARNING
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
it should only be replaced by the manufacturer or at a
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
Before gaining access to the terminals all power sources should be disconnected.
WARNING
Power Requirements
WARNING
• The tool shall be grounded while in use to prevent electric shock.
The welder shall be set up as close as possible from the main power source. Check the supply carries the same voltage
indicated in the motor nameplate.
WARNING
• This tool shall be grounded.
• Power cables are coded with the following colors:
CAUTION
• When using the welder together with more tools sharing the same ground, connect in parallel. Never in series.
CAUTION
• The gauge of the ground conductor cable shall not be of a smaller gauge than the power supply cable.
CAUTION
• A professional electrician shall carry out the connection to the power supply.
• Always confirm the input voltage connection stated in the welder nameplate matches the power
CAUTION
supply.
CAUTION
• The power cable gauge shall comply with the following requisites:
Switch
Fuse (Rated Work Current)
Electric Wire
* Fuse fusion current is double than its rated current.
Code
Description
Voltage
Frequency
Current
Work Cycle
Weight
Insulation
Conductors
30 A
55 A ( * )
2,5 mm
2
SOIN-250
17411
Inverter welder
Input
220 V
60 Hz
55 A
12,1 kVA
2 Phases
Output
SMAW: 76 V cc
30 A - 250 A
50% 5 minutes' work per 5 minutes' rest.
The output values specified are given to a 68 °F
In higher temperatures, the work cycle shall be reduced.
Fan Forced
19 lb
Class I
H07RN-F x 3G (4,0 mm
) with 221 °F insulation temperature
2
Power cord grips used in this product: Type "Y".
Build quality: Basic insulation
Thermal insulation on motor winding: Class H
Authorized Service Center.
GREEN
WHITE
BLACK
• If extension cables are needed between the welder and
the work piece increase the welding cable caliber to keep
the welder power output with a potential drop not higher
than 4 V
TIG: 14,5 V cc
IP Grade
IP21S
GROUND
CURRENT
CURRENT
ENGLISH
3
3
Publicidad
