Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (SMAW)
Connections
To prevent an electric shock, the user must
CAUTION
see the information in "Power Requirements" in page 3 and 5.
• The fast connections of the electrode holder and the ground
clamp are inserted and turned one quarter of a turn in a
clockwise direction in the outlets set in the front panel to
secure perfectly.
• Press the upper arrow in the process selector to set the
welder working in SMAW mode
(coated electrode).
The upper LED in the
NOTE
selector will light on.
Reverse Polarity (A)
• Connect the grounding clamp cable
to the negative (-) output clamping screw of the welder.
• Connect the grounding clamp (C) to the work piece.
• Connect the electrode holder cable to the positive (+)
output clamping screw of the welder.
This configuration generates more heat in the electrode,
which produce more penetration with basic electrodes,
making it ideal to weld thick pieces.
Direct Polarity (B)
• Connect the grounding clamp cable to the positive (+)
output.
• Connect the grounding clamp (C) to the work piece.
• Connect the electrode holder cable to the negative (-) output.
This configuration generates more heat in the work piece, thus
producing less malformation in the work piece and narrower joints
making it ideal for thin pieces.
• Connect the power cable (D) to the power network to the work
voltage (220 V ).
WARNING
Before using the welder, it shall be correctly
grounded. The ground cable shall not be uninstalled because it
propitiates severe bod injuries.
C
Metal
Work Table
C
Led
Set the electrode
that is adequate
for the job into the
electrode holder
A
Reverse Polarity
B
Direct Polarity
C
D
ENGLISH
7
Publicidad
