Display stand by mode management
•
If the door is closed -> display in standby (all LEDs switched off)
If the door is open -> current fridge temperature LED and freezer temperature
•
LED are turned on (fixed).
•
ECO mode LED + Holiday mode LED are turned on (fixed) if previously selected.
Display is ready to receive inputs (no need to activate it by touch).
•
Mode
The mode button is used to switch between the different modes.
The related LED turns on and selection is immediately confirmed (no blink).
Short acoustic feedback confirms the selection.
Fridge temperature setting
When display panel is on, select the "fridge temperature setting" pushing the MODE button.
The fridge area LED turns on. Push the "TEMP" button until the desired temperature is set.
The temperature value changes in this way: 8℃ -> 6℃ -> 4℃ -> 3℃ -> 2℃ -> super cooling -
> 8℃...
The related LED turns on and selection is immediately confirmed (no blink).
Short acoustic feedback confirms the selection.
Freezer temperature setting
When display panel is on, select the "freezer temperature setting" pushing the MODE
button. The freezer area LED turns on.
Push the "TEMP" button until the desired temperature is set.
The temperature value changes in this way: -16℃ -> -18℃ -> -20℃ -> -22℃ -> -24℃ ->
Super freezing->-16℃...
The related LED turns on and selection is immediately confirmed (no blink).
Short acoustic feedback confirms the selection.
Note
Switching from fridge to freezer areas and vice versa is immediate when the user pushes
the MODE button, and the selection is immediately active.
Temperature LEDs do not blink.
EN 4