Publicidad
Idiomas disponibles
Idiomas disponibles
6. Instructions for Use
6.1. Activating Fall Arrest Mode
Models: GSE414G, GSE410SSK & GSE414P
i.
Hold the snap hook to stop the lifeline retracting into the unit.
ii.
Pull out and hold the Retrieval Mechanism Locking Trigger.
iii. Pull the Crank Arm away from the SAVER housing to disengage the retrieval
mechanism.
iv.
Release the Retrieval Mechanism Locking Trigger.
v.
Confirm the fall arrest brake engages by quickly pulling down on the snap hook.
Models: GSE430G, GSE425SSK & GSE430P
i.
Pull out and hold the Retrieval Mechanism Locking Trigger.
ii.
Push the Crank Arm towards the SAVER housing to engage fall arrest mode. The Crank
Arm can be rotated slightly to assist engagement.
iii. Release the Retrieval Mechanism Locking Trigger.
iv.
Confirm the fall arrest brake engages by quickly pulling down on the snap hook.
!
6.2. Attaching to the User
•
The SAVER can only be used in conjunction with a full-body harness which conforms
to all national standards and regulations applicable.
•
The SAVER can only be used with full-body harnesses which conform to;
i.
ii.
iii.
•
The SAVER must only be connected to the D-ring on the front or back of the full-body
harness.
•
Connect the SAVER's snap hook directly to the fall arrest attachment point of the full-
body harness. Ensure the snap hook gate is closed and locked.
Do not allow the lifeline to freely retract into the unit while it is in
fall arrest mode.
Always leave the SAVER in fall arrest mode when it is not being
used.
IMPROPER USE MAY RESULT IN SERIOUS INJURY OR DEATH.
EN 361; or
ANSI/ASSP Z359.11; or
CSA Z259.10
WARNING
14
Publicidad
