Surge Protector Shelf Wall Tap Outlet with USB and Night Light
3. Make sure equipment is turned off before plugging into the
wall tap outlets. Do not use extension cords to connect
equipment to the wall tap.
4. Connected equipment can now be turned on.
5. Hold the wall tap firmly against the wall when removing plugs to prevent it from pulling
loose.
6. When the switch is in the OFF position, the night light is OFF; when in the ON position,
the light will stay ON. When the switch is in the AUTO position, the light automatically turns
ON when the area around the light is dark, and back OFF when the area is illuminated.
USB Charging
2.4Amp total output allows you to charge one tablet or two smart phones at the same time.
Recharge your device at a maximum speed of 2.4Amp when connected to a single port.
NOTICE:
The USB ports are used to charge portable electronic devices only. There is no
data transfer capability.
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
FCC NOTE:
The manufacturer is not responsible for any radio or TV interference
caused by unauthorized modifications to this equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equip-
ment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions may cause harmful interference to radio communications.
However, there in no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on.
5