Hatco HBG Serie Manual De Instalación Y Operación página 3

Read the following important safety information before using this equipment to avoid
serious injury or death and to avoid damage to equipment or property.
WARNING
ELECTRIC SHOCK HAZARD:
• Plug unit into a properly grounded
electrical receptacle of the correct
voltage, size, and plug configuration. If
plug and receptacle do not match, contact
a qualified electrician to determine and
install proper voltage and size electrical
receptacle.
• Turn OFF power switch, unplug power
cord, and allow unit to cool before
performing any cleaning, setup, or
maintenance.
• DO NOT submerge or saturate with water.
Unit is not waterproof. Do not operate if
unit has been submerged or saturated
with water.
• Unit is not weatherproof. Locate unit
indoors where ambient air temperature
is a minimum of 21°C (70°F).
• Remote mounted control panel must be
mounted on a vertical wall and installed
in vertical position. Mounting control
panel in horizontal position may result
in collection of liquids and lead to an
electric shock.
• This unit is not "jet-proof" construction.
Do not use jet-clean spray to clean this
unit.
• Do not pull unit by power cord.
• Discontinue use if power cord is frayed
or worn.
• Do not attempt to repair or replace a
damaged power cord. Cord must be
replaced by Hatco, an Authorized Hatco
Service Agent, or a person with similar
qualifications.
• Do not clean unit when it is energized or
hot.
• Use only Genuine Hatco Replacement
Parts when service is required. Failure
to use Genuine Hatco Replacement
Parts will void all warranties and may
subject operators of the equipment to
hazardous electrical voltage, resulting
in electrical shock or burn. Genuine
Hatco Replacement Parts are specified
to operate safely in the environments in
which they are used. Some aftermarket
or generic replacement parts do not have
the characteristics that will allow them to
operate safely in Hatco equipment.
Form No. HBGCEM-0520
IMPORTANT SAFETY INFORMATION
FIRE HAZARD: Locate unit a minimum of
25 mm (1") from combustible walls and
materials. If safe distances are not maintained,
combustion or discoloration could occur.
Make sure food product has been heated
to the proper food-safe temperature before
placing on the unit. Failure to heat food
product properly may result in serious health
risks. This unit is for holding preheated food
product only.
This unit is not intended for use by children
or persons with reduced physical, sensory,
or mental capabilities. Ensure proper
supervision of children and keep them away
from the unit.
Make sure all operators have been instructed
on the safe and proper use of the unit.
This unit has no "user-serviceable" parts.
If service is required on this unit, contact
an Authorized Hatco Service Agent or
contact the Hatco Service Department at
+1-414-671-6350.
BURN HAZARD: Some exterior surfaces on
unit will get hot. Use caution when touching
these areas.
Locate unit at proper counter height in an
area that is convenient for use. Location
should be level to prevent unit or its
contents from falling accidentally and
strong enough to support the weight of the
unit and contents.
Do not operate built-in models without
control box mounted properly as described
in the installation instructions.
The National Sanitation Foundation (NSF)
requires that units over 36" (914 mm) in width
or weighing more than 80 lbs. (36 kg) either
be sealed to or raised above the installation
surface. If unit cannot be sealed at the point
of use, 4" (102 mm) legs are included to allow
for proper cleaning access below unit.
Pitting or indentation in glass surface
may occur from sugary spills. If pitting or
indentation occurs, glass surface must be
replaced. To prevent further damage and
possible injury from broken glass, stop
using unit immediately and contact an
Authorized Hatco Service Agent.
3
WARNING
CAUTION