SMA HS-BM-3.28-10 Instrucciones Breves página 5

SMA Solar Technology AG
1.5 Symbols in the Document
Icon
2 Safety
2.1 Intended Use
SMA Home Storage is a battery module and can be used in the SMA Home Storage Solution for
home applications, including for increasing self-consumption.
The communication interface of the inverter used must be compatible with the product. The entire
voltage range must be completely within the permissible input voltage range of the inverter. The
maximum permissible DC input voltage of the product must not be exceeded.
No additional loads or components in the DC intermediate circuit may be connected between the
battery and inverter.
All components must remain within their permitted operating ranges and their installation
requirements at all times.
The product must only be used as stationary equipment.
The product is not suitable for supplying life-sustaining medical devices. A power outage must not
lead to personal injury.
The product must only be used in countries for which it is approved or released by SMA Solar
Technology AG and the grid operator.
Use SMA products only in accordance with the information provided in the enclosed
documentation and with the locally applicable laws, regulations, standards and directives. Any
other application may cause personal injury or property damage.
Alterations to the SMA products, e.g., changes or modifications, are only permitted with the express
written permission of SMA Solar Technology AG. Unauthorized alterations will void guarantee and
warranty claims and in most cases terminate the operating license. SMA Solar Technology AG
shall not be held liable for any damage caused by such changes.
Any use of the product other than that described in the Intended Use section does not qualify as
appropriate.
The enclosed documentation is an integral part of this product. Keep the documentation in a
convenient, dry place for future reference and observe all instructions contained therein.
This document does not replace any regional, state, provincial, federal or national laws, regulations
or standards that apply to the installation, electrical safety and use of the product. SMA Solar
Technology AG assumes no responsibility for the compliance or non-compliance with such laws or
codes in connection with the installation of the product.
The type label must remain permanently attached to the product.
Quick Reference Guide
Explanation
Information that is important for a specific topic
or goal, but is not safety-relevant
Section in which the installation and commission-
ing process is illustrated graphically.
HS-BM-328-10-IS-xx-11
2 Safety
5