Napoleon 410SB Manual De Instrucciones página 6

6 Lighting Instructions
EN
WARNING!
WARNING!
valve.
2. Push and turn any main burner
knob slowly to the 'hi' position. This
action will ignite the pilot flame
which will in turn light the selected
burner. If the pilot lights, continue to
push down on the control knob until
the burner lights and then release.
3. If the pilot does not ignite, then
immediately turn the control knob
back to the 'off position and repeat
step 2 several times.
4. If the pilot and burner will not
ignite within 5 seconds, turn the
control knob to the 'off' position and
wait 5 minutes for any excess gas to
dissipate. Either repeat steps 2 and 3
or light with a match.
5. If lighting the unit with a match,
clip the match into the supplied
lighting rod. Hold the lit match down
through the grill and sear plate while
turning the corresponding burner
www.napoleongrills.com
Left Burner
Open lid.
Ensure all burner controls are in the off position. Turn on the gas supply
Main Burner
Lighting
1. Open grill lid.
burner control knob slowly to the
'hi' position. This action will ignite
. light the burner. If the pilot lights,
continue to push down on the burner
control knob until the burner lights
4. If the burner does not ignite, then
immediately turn the control knob
back to the 'off' position and repeat
5. If the burner will not ignite within
5 seconds, turn the control knob to
the 'off' position and wait 5 minutes
for any excess gas to dissipate. Either
repeat steps 3 and 4 or light with a
valve to high.
Centre Burner Right Burner
Rear Burner Lighting
(If equipped)
1. Open grill lid.
2. Remove the warming rack.
3. Push and turn the rotisserie
the pilot flame, which will in turn
then release.
step 3 several times.
match.
Side Burner
Off Position
Side Burner Lighting
(If equipped)
1. Open side burner cover.
2. Push and turn the side burner
control knob slowly to the
'hi' position. This action will ignite
the side burner.
3. If the burner does not ignite, then
immediately turn the control knob
back to the 'off' position and repeat
step 2 several times.
4. If the burner will not ignite within
5 seconds, turn the control knob to
the 'off' position and wait 5 minutes
for any excess gas to dissipate. Either
repeat steps 2 and 3 or light with a
match.