Publicidad
Idiomas disponibles
Idiomas disponibles
function. The symbol is displayed on the LED panel.
7.
COOLING
Press button again to turn off. If you want to operate the unit with water for
better cooling, pull out the water tank and fill it up to the MAX mark at the
most. Take care when doing so, to make sure, that no water enters the
product, e.g. through the air inlet.
ATTENTION ABOUT ICE BOX
Then put a ice box in the water tank ( the ice box needs to be frozen for more
than 3 hours), and the cooling effect is better ( Note: when the water tank is
short of water, it is forbidden to use, please add water in time).
8. Display
the remote or by pressing and holding the SPEED button on the control
panel for more than 3 seconds, the display will light up again once any
control button is activated.
MAINTENANCE
1.
This can only be done by an authorized service agent such as your local
Sealer dealer or any agent qualified to undertake electrical repairs.
2. If the unit requires external cleaning make sure it is switched off and
unplugged from the mains supply. Use a soft tissue or cloth for general
cleaning. To remove more persistent dirt or grime wipe down with a cloth that
has been dampened with warm soapy water. Do not use any solvents ( such
as thinners ) as these may damage the plastic casing.
: Press 'COOLING' button to turn on the cold air function.
: Can be switched off temporarily by press the LED button on
10
Publicidad
