Publicidad
Idiomas disponibles
Idiomas disponibles
•
Never immerse the appliance in water and make sure that no
water or moisture penetrates the upper part of the Smart Fryer.
•
Clean the heating element inside the Smart Fryer with a cleaning
brush to remove any food residue.
Cleaning the Smart Fryer's exterior
•
Wipe clean with a damp sponge or cloth. Wipe dry.
•
NEVER use steel wool, metal scouring pads or abrasive cleaners, as
they may damage the finish.
•
Do not let any liquids enter the air inlet on the top of the Smart Fryer.
Any other servicing should be performed by an authorized service
representative.
DO NOT IMMERSE THE FRYER IN WATER OR ANY OTHER LIQUID!
TROUBLESHOOTING
Problem
The Smart Fryer
does not work
The ingredients fried
with the Smart Fryer
are not done.
Fried snacks are not
crispy when they
come out of the
Smart Fryer.
I cannot slide the
basket into the
appliance properly.
www.KALORIK.com
Possible cause
The appliance is either
not plugged in or
switched on.
You have not set the
timer.
The basket holder is not
properly locked.
There is too much food
in the basket.
The set temperature is
too low.
The cooking time is too
short.
You used a type of
snack meant to be
prepared in a traditional
deep fryer.
There is too much food
in the basket.
Make sure the main plug is inserted in an
electrical wall socket and press the
Press the timer control buttons to the
required preparation time and press
"On/Off" again to switch on the
Push the basket holder back in the
Smart Fryer properly.
Put smaller batches of ingredients in the
basket. Smaller batches are fried more
Adjust the temperature to the required
temperature setting (see section
Adjust the timer to the required
preparation time (see section 'Settings')
Use snacks made to be prepared in the
oven, or lightly brush some oil onto the
snacks for a crispier result.
Do not fill the basket to capacity; refer to
the "Setting" table above for maximum
14
Solution
On/off key.
appliance.
evenly.
'Settings')
quantities.
FT 44751 - 180330
Publicidad
