Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 5 Power on
Plug the power cord into an AC 120 V / 60 Hz / 15 AMP approved electrical outlet protected by a 15-amp fuse
or circuit breaker. Then, press POWER to turn on the washer.
STEP 6 Run a test cycle
Run a test cycle as follows to check if your washer is properly installed.
1. Load about 6 lb. of laundry into the tub.
2. Press POWER to turn on your washer.
3. Turn the Cycle Selector to RINSE+SPIN.
4. Press START/PAUSE to start the test cycle.
5. The washer should not rock or vibrate excessively when water is supplied or when washing and spinning,
and should drain well during the spin cycle.
NOTE
• If water leaks while water is being supplied or drained, check the water connections. See "Connect the
water hose" on page 18.
• If the washer rocks and vibrates excessively, level your washer again. See "Level the washer" on page 21.
Untitled-4 23
With the leg ring in place, use the leveling leg to adjust
the height of the washer.
English 23
2023-06-22
2:27:58
Publicidad
